Vizahn Adobe is a trademark of Adobe Systems Incorporated. The design of the housing for the seal shall be in accordance with the dimensions specified in ISO For dated references, only the edition cited applies. Damaged sealing ido incorrect installation use proper installation methods careless handling during transport and storage, the rings should be packed 7. It is the responsibility of the user of this part of ISO to establish appropriate safety and health practices and to ensure compliance with any national regulatory conditions.
|Country:||Trinidad & Tobago|
|Published (Last):||15 August 2019|
|PDF File Size:||19.47 Mb|
|ePub File Size:||9.49 Mb|
|Price:||Free* [*Free Regsitration Required]|
Revisions British Standards are updated by amendment or revision. Typically, the shaft rotates, and the housing is stationary, although in some applications the shaft is stationary, and the housing rotates. Detailed questions should be directed to the Manufacturer.
The housing and the rotating member shall be capable of reproducing the eccentricity and off-set specified in 4. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. Where the seal is required for the low-temperature stiffness test, ensure that the seal manufacturer has also stated the maximum modulus after test at the selected test temperature.
Ensure that the batch of elastomer has been tested in accordance with Clause 7. Nominal dimensions and tolerances  ISO If the dimension of the test piece is greater than 4 mm, then the normal test procedure shall be used. Excessive wear or hardening of the lip pressure deaerate the sealing chamber no grease supply grease to the ring improperly selected material for a particular change the ring material 4. Information on standards BSI provides a wide range of information on national, European and international standards through its Library and its Technical Help to Exporters Service.
It presents the UK view on standards in Europe and at the international level. It is the constant aim of BSI to improve the quality of our products and services. ISO — Rotary shaft lip type seals — Part 2: Vocabulary Inspect the seal lip, noting any cracks, tears, splits or any imperfections that may have appeared as a of the test.
Damaged spring incorrect installation use proper installation methods. Storage, handling and installation  ISO Avoid unnecessary stretching of the spring during installation. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. The Manufacturer reserves the right to introduce changes, according to new technical solutions and progress in the area of technologies and materials.
Except as permitted under the Copyright, Designs and Patents Act no extract may be reproduced, stored in a retrieval system or transmitted in any form or by any means — electronic, photocopying, recording or otherwise — without prior written permission from BSI.
Adobe is a trademark of Adobe Systems Incorporated. The test specimens shall be similar to those used for the hardness test see 7. Unless otherwise agreed between the supplier and purchaser, tests shall be in accordance with 7. Shaft wear filings and other impurities clean the elements before the installation. A list of organizations represented on this committee can be obtained on request to its secretary. TOP 10 Related.
ISO 6194-2 PDF