What is the subnet mask for these networks in dotted decimal format? Subnet 0 will be available for future expansion. Task 2: Determine Interface Addresses. Step 1: Assign appropriate addresses to the device interfaces. Assign the last valid host address in subnet 1 to PC2. All rights reserved.
|Published (Last):||19 December 2010|
|PDF File Size:||19.71 Mb|
|ePub File Size:||17.44 Mb|
|Price:||Free* [*Free Regsitration Required]|
As the network grows in size, this becomes an administrative problem when devices are moved from one internal network to another. In this scenario, the company has grown in size, and the network administrators can no longer assign IP addresses to devices manually. Your job is to configure the R2 router to assign IPv4 addresses on two different subnets connected to router R1.
However, the required commands are provided in Appendix A. Test your knowledge by trying to configure the devices without referring to the appendix.
Other routers, switches, and Cisco IOS versions can be used. Depending on the model and Cisco IOS version, the commands available and the output produced might vary from what is shown in the labs. Refer to the Router Interface Summary Table at the end of this lab for the correct interface identifiers. Note: Make sure that the routers and switches have been erased and have no startup configurations.
If you are unsure, contact your instructor. Instructor Note: Refer to the Instructor Lab Manual for the procedures to initialize and reload devices.
You will also configure the IP settings for the PCs in the topology. Step 1: Cable the network as shown in the topology. Step 2: Initialize and reload the routers and switches. Step 3: Configure basic settings for each router. Console into the router and enter the global configuration mode. Copy the following basic configuration and paste it to the running-configuration on the router.
CCNA RSE 184.108.40.206 Lab – Configuring Basic DHCPv4 on a Router
Lab 2.8.2. Challenge Static Route Configuration